Remove one of the USB plugs and cut the end off to see were we are at with space. Snip the outer covering and sheilding to get to the four wires we need access to. We don't want to add that thick cable to the camcorder.

The plug fits well inside of the case. I will use my key hole saw to cut the tab so it can slide over the tab on the CVS case. Below is the first test to see if the eletronics will fit back in with the plug just resting in there. Screw holes dont line up perfectly so I wil take a small chunk out of the plug where the speaker and lense are located.

Things are fitting like a charm right now. Time to cut the case and mount the USB plug. Since i am using the tab to hold one side of the plug, I will just use one screw hole to mount the plug. First run with the dremel on the case gives me a hole that is a little on the small side.

Spending a little more time and using my Xacto Knife I get the holes that I want.